Halloween Coasters - base coaster and smile

Coaster's base with smile

Materials:

• yarn - color You desired ( I use the yarn which gauge is 24.0 to 30.0 sts = 4 inches )
• hook 3 mm

Base Pattern:

R1. Start witch 3 ch in MR (pic.1), then make 11 dc in MR, end by making ss in 3-rd chain (12 dc I am counting 3 ch as first dc)

R2: 3 ch, dc in same ch as 1-st ch, *2 dc in 1* around, ss in 3-rd ch (24 dc)

R3:  3 ch, dc in same ch as 1-st ch, * dc, 2 dc in 1 * around, ss in 3-rd chain (36 dc) 

R4:  3 ch, dc in same ch as 1-st ch, * dc 2, 2 dc in 1 * around, ss in 3-rd chain (48 dc) 

R5:  3 ch, dc in same ch as 1-st ch, * dc 3, 2 dc in 1 * around, ss in 3-rd chain (60 dc) 

R6: 1 ch, * sc 4, inc * around, ss in 1-st ch (72) FO

Final effect in different colors:

Smile Pattern

white yarn ( you can also use yellow maybe for different effects)








R1: 20 ch (20)

R2: ss in 2-nd ch, ss, sc 6, *2dc in 1* X3,
sc 6, ss, ss (22)

R3: TURN ss in 2-nd ch, ss, sc 16, ss 2 (20)

R4: TURN ss in 2-nd ch, ss 2, sc 4, inc, sc 2, inc, sc 4, ss 3 (20) FO

Symlink black yarn and make ss in each ch around smile. You will make black outline. 

Now we will make teeth gaps with black yarn. When You are making the outline after FO leave a long tail of yarn (15 cm should be enough) Pull the whole yarn to the front side of smile(1-st pic. below). Make the first gap by pulling the yarn to the back side in the right place(2-nd pic.) and fastening it with thread( 3-rd pic.). Continue making gaps ( 4, 5,6 , 7, 8-th pic.). Tightly fasten the end of thread with yarn (9-th pic.)